Can we connect switches to the binary inputs in Zennio products?

From Spain we have been asked if it is possible to connect sensor switches to the binary inputs of our products or if only push buttons can be connected to them.

The difference between these two types of switches is when the status detection of the signal is carried out. In the push bottoms the signal is detected during the pulse while in the sensor switches the status is determined by the falling or the raising edge.

The answer is that we can connect both types of switches to our products counting on binary inputs:

Actuator ACTinBOX Classic

QUAD

With the exception of the Touch Panel Z38 where we can only connect push buttons.